SPA3000 Unlocked Linksys Internet Phone Adapter VoIP Gateway PSTN 1 FXO 1 FXS


Condition:New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is ... Read moreModel:SPA-3000
MPN:Does Not ApplyInterface:Ethernet (RJ-45)
Country/Region of Manufacture:ChinaUPC:757290002695


VoIP to PSTN (USA) Service Call Origination and TerminationPSTN (USA) to VoIP Service Call Origination and Termination

Single or Dual Stage Dialing

Service Authentication via PIN, Digest, Caller ID (Bellcore Type 1)

Per Call Authentication and Associated Routing

Least Cost Routing Support

Impedance Agnostics - 8 Settings

Call Waiting, Cancel Call Waiting, Call Waiting Caller ID Detection (Bellcore Type 1)

Caller ID with Name/Number (Multi-national Variants)

Caller ID Blocking

Call Forwarding to PSTN or VoIP Service: No answer, Busy, All

Do Not Disturb

Call Transfer

Three-way Conference Calling with Local Mixing

Message Waiting Indication - Visual and Tone Based

Call Return

Call Back on Busy

Call Blocking with Toll Restriction

Delayed Disconnect

Distinctive Ringing - Calling and Called Number

Off-hook Warning Tone

Selective/Anonymous Call Rejection

Hot line and Warm Line Calling

Speed Dialing of 8 Numbers/Addresses

Music on Hold

SPA3000 Specific

Forward Calls to VoIP service - Selective, Authenticated, All

Forward Calls to PSTN service - Selective, Authenticated, All

PSTN Line Sharing with Multiple Extensions

Automatic PSTN Fallback (Loss of Power or IP Service to Unit - with Quiescence to Normal Operations)

Advanced Inbound and Outbound Call Routing

Single Stage and Two Stage Dialing

Independent Configurable Dial Plans - Up to 8

Force PSTN Disconnection

Sequential Dialing Support

VoIP to PSTN Authentication and Routing

VoIP to PSTN Gateway Enable/Disable

VoIP Caller Auth Method (None, PIN, HTTP Digest)

VoIP PIN Max Retry Setting

One Stage Dialing Enable/Disable

VoIP Caller ID Pattern Matching

VoIP Access Allowed Caller List (No Further Authentication)

VoIP Caller PIN and Associated Dial Plan

PSTN to VoIP Authentication and Features

PSTN to VoIP Gateway Enable/Disable

Caller Auth Method: None, PIN, Caller ID

Ring Through to FXS Enable/Disable

Ring Through Tone - Configurable

Caller ID (Bellcore 1) for VoIP Service Access

Caller ID Enable/Disable

PIN Max Retry Settings

Access Allowed Caller List (No Further Authentication)

Caller PIN and Associated Dial Plan

Least Cost Routing (via Outbound VoIP - Line1 Dial Plan)

International Control

FXO Port Impedance - Configurable to 16 settings

Ring Frequency - Configurable

SPA to PSTN and PSTN to SPA Gain Settings

Ring Frequency - Maximum Setting

Ring Validation Time Setting

Tip/Ring Voltage Adjustment Setting

Ring Indication Delay Setting

Operational Loop Current Minimum Value

Ring Time-out Setting

On-Hook Speed Setting

Ringer Impedance Setting

Line-in-Use Voltage Setting


Password Protected System Reset to Factory Default

Password Protected Admin and User Access Authority


HTTP Digest - Encrypted Authentication via MD5 (RFC 1321)

Up to 256-bit AES Encryption


Quick-Start Installation and Configuration Guide

User Guide

Administration Guide - Service Providers Only

Provisioning Guide - Service Providers Only

Physical Interfaces:

1 10baseT RJ-45 Ethernet Port (IEEE 802.3)

1 RJ-11 FXS Phone Ports - For Analog Circuit Telephone Device (Tip/Ring)

1 RJ-11 FXO Phone Ports - For a Telco or PBX Connection

FXS: Subscriber Line Interface Circuit (SLIC):

Ring Voltage: 40-55 VRMS Configurable l*

Ring Frequency: 10 Hz - 40 Hz l*

Ring Waveform: Trapezoidal and Sinusoida l*

Maximum Ringer Load: 3 REN

On-hook/off-hook Characteristics:

On-hook voltage (tip/ring): -50 V NOMINAL

Off-hook current: 25 mA min

Terminating Impedance: 8 Configurable Settings including

North America 600 ohms, European CTR21

Power Supply:

DC Input Voltage: +5 VDC at 2.0 A Max.

Power Consumption: 5 Watts

Switching Type (100-240v) Automatic

Power Adapter: 100-240v - 50-60Hz (26-34VA) AC Input, 1.8m cord

Package include: (No Retail box!)

1* Unlocked Linksys SPA3000

1* Universal Power Adapter (100-240V)

1* Network cable